Edi,

A countersunk hole is simply a normal right cylindrical through-hole with an
additional right conical section removed for accepting a flat head screw.
The cone angle is typically 82 or 100 degrees. The diameter of the smaller
end of the conical section is the same size as the hole and the diameter of
the larger end depends on both the angle and the thickness of the material.
The creation of a countersunk hole is performed using a special countersink
drill bit or a drill bit and angle end mill in combination.


> -----Original Message-----
> From: Edi Im Hof [mailto:[EMAIL PROTECTED]]
> Sent: Friday, January 11, 2002 07:28
> To: Protel EDA Forum
> Subject: Re: [PEDA] Countersunk holes
> 
> 
> At 12:39 11.01.02 +0100, you wrote:
> >----- Original Message -----
> >From: "Edi Im Hof" <[EMAIL PROTECTED]>
> >
> > > Thanks to all for the answers. I first thought about a much more
> > > complicated thing. Something for HF or so.
> > > I tried two translators, none of them had a translation for this.
> >
> >
> >try this one:
> >
> >http://dict.leo.org/?search=countersink&searchLoc=0&relink=on
&deStem=standar
> >d&lang=de
> 
> Emm.. I tried this with no sucess! May I have mistyped it.
> Now I found it.
> 
> Edi
> 
> 
> >            .....
> >            ô ô )
> >-----oOOo--(_)---oOOo------
> >
> >Ralf Guetlein
> >Biotest Medizintechnik GmbH
> >Industriestrasse 19
> >D-63755 Alzenau
> >Germany
> >---------------------------
> >Tel. +49 6023 9487-42
> >Fax. +49 6023 9487-35
> >[EMAIL PROTECTED]
> >---------------------------
> >
> >
> 
> 
> 
> ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
> +  IH electronic                +  Phone:   ++41 52 320 90 00  +
> +  Edi Im Hof                   +  Fax:     ++41 52 320 90 04  +
> +  Doernlerstrasse 1, Sulz      +  URL:     http://www.ihe.ch  +
> +  CH-8544 Rickenbach-Attikon   +  E-Mail:  [EMAIL PROTECTED]   +
> +  Switzerland                  +                              +
> ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to