The board can still be auto routed with arcs on the keep out for the
border, it just ignores them. Have you run the drc, or check to see if you
have any violations on the navigation panel. What was the last trace size
that you placed? If I remember right that auto router will default to the
last track size you placed.Ted -----Original Message----- From: Mark E Witherite [mailto:[EMAIL PROTECTED]] Sent: Thursday, January 24, 2002 4:45 PM To: Protel EDA Forum Subject: Re: [PEDA] Autoroute error message Do you have any arcs in your keep out layer? At 02:13 PM 1/24/02 -0600, you wrote: >I know I have seen this error before but I can't remember how to fix it. >When I try to start the autorouter it tells me that one or more connections >cannot be routed due to design rule violations. I have checked the border of >the board and it is fine there are no gaps and the outline is on the keepout >layer. I haven't seen this in a long time and am at a loss to figure it out. >Any help would be appreciated. >Nick Cobb > Mark Witherite C.I.D. Assistant Research Engineer Astronomy & Astrophysics Penn State University 2565 Park Center Blvd Suite 200 State College, PA. 16801 email [EMAIL PROTECTED] telephone 814 865 9839 fax 814 865 9100 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
