the solution i have found to work best is to not use component clearance
rules
Dennis Saputelli
Pat Lyons wrote:
>
> I am trying to set component clearance rules to allow small
> components to overlap the bounding box of larger components
> or oddly shaped components. As an example allowing surface
> mount filter caps to sit tightly against the pins of a TO-220.
> Setting negative clearance between the 2 classes of components
> does not seem to accomplish this.
>
> Jayhawk Design
> -- Pat Lyons, [EMAIL PROTECTED] on 02/05/2002
>
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
