I have the following problem: I making a new component in a PCB library.
This component must have 2 pads with the same number, another pad has to be
connected to a fill. Is this possible without errors being generated in the
PCB'c DRC? How do I solve this?
Regards,
============================================================================
I N T E R S O F T E L E C T R O N I C S n.v.
Radar verification Hard- & software
Timetronics : Fotofinish and timing of sportevents
RS-Scan : Footscan applications
and more ...
ing. Danny Van den Bliek
[EMAIL PROTECTED] ( work )
[EMAIL PROTECTED] ( home )
[ ATC Development Team - Hardware Engineer ]
Lammerdries 27
B - 2250 Olen
Belgium Europe
Tel: +32 14 23.18.11
Fax: +32 14 23.19.44
Checkout http://www.intersoft-electronics.com
also: [EMAIL PROTECTED]
[EMAIL PROTECTED]
============================================================================
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
