Unfortunately, single-layer mode has not be implemented in the best way.

It was apparently designed to be used for viewing, not really for editing. 
The solution might be for Protel to disable selection entirely in 
single-layer mode, or make single-layer mode edit the same as having the 
same layers enabled in the Layer dialog.

There are other problems as well.... We'd like to use single-layer mode to 
route on a single layer, especially where there are blind/buried vias, but 
display does not work properly, as has been dsicussed at length in the past.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to