Hi,
   I was wondering if it is possible to stop Protel placing vias under /any/
components as the only method of manufacture I have is pin and hole
vias. Protel places vias under P&H components (which I'm not /so/
bothered about) but also under SM ones! I thought that rule stopped that
but it turns out the rule only stops vias under SMD pads!

Is there a plugin available or similar that will help?! Thanks
Gareth


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to