I did but it makes very little sense... I understood only SIGNAL LAYERS and INTERNAL PLANES...
These are the one i need more info on: > Top/Bottom Paste layer > Top/Bottom Solder layer > Drill Guide layer > Drill Drawing layer > Silkscreen > Part Numbers layer > Template_Dimensions layer Plus add one more... >Mechanical Layer Best Regards, Waheed Bajwa ================================== Design Engineer Communications Enabling Technologies Software Technology Park, 5-A Constitution Avenue, Islamabad - 44000 Pakistan Ph. No: +92-51-2826160 Ext. 254 http://www.enabtech.com ================================== ----- Original Message ----- From: "Thomas" <[EMAIL PROTECTED]> To: "'Protel EDA Forum'" <[EMAIL PROTECTED]> Sent: Friday, May 17, 2002 11:37 AM Subject: Re: [PEDA] Some more info > Have a look at "PCB design layers" in the help file. > > Tom > > -----Original Message----- > From: Waheed Bajwa [mailto:[EMAIL PROTECTED]] > Sent: Friday, 17 May 2002 5:17 PM > To: Protel EDA Forum > Subject: [PEDA] Some more info > > > Ok here are some more information requiring issues... > > What is: > > Top/Bottom Paste layer > Top/Bottom Solder layer > Drill Guide layer > Drill Drawing layer > Silkscreen > Part Numbers layer > Template_Dimensions layer > > Thanx... > > Best Regards, > Waheed Bajwa > > ================================== > Design Engineer > Communications Enabling Technologies > Software Technology Park, > 5-A Constitution Avenue, > Islamabad - 44000 > Pakistan > Ph. No: +92-51-2826160 Ext. 254 > http://www.enabtech.com > ================================== > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
