thank brad and mike

i know some reps well but the customer will be shopping it offshore
an inquiry like this to the reps will make my phone ring too much (BTDT)

info on FR1 was v interesting

Dennis Saputelli


Mike Reagan wrote:
> 
> Dennis,
> 
> Check with some of your manufacture's reps in your area.  I know a few reps
> in our area represent board houses in Malaysia, Korea, etc.   If every dime
> counts,  as well it should, I would look to overseas fabrication.  I am sure
> you will be able to find a rep in your area.
> 
> Mike Reagan
> EDSI
> 
> ----- Original Message -----
> From: "Dennis Saputelli" <[EMAIL PROTECTED]>
> To: "Protel EDA Forum" <[EMAIL PROTECTED]>
> Sent: Thursday, May 30, 2002 12:34 PM
> Subject: Re: [PEDA] Help re bd material
> 
> > can anyone advise me on the following please?
> >
> > i am about to do a design for a 150,000 pc run
> > for cost reasons (low end commercial product) the bd material must be
> > made out of night soil (actually phenolic)
> >
> > the design is SMD and to be a single sided bd (one etch layer)!
> >
> > the lead pitch is 0.5mm on a 108 PQFP and a 48 PQFP
> >
> > trace density and net count will be low so i think it will be routable
> >
> > so the question is:
> > are there etch considerations, lead pitch minimums or other
> > considerations regarding the material?
> >
> > i.e. can you actually put a 108 PQFP on phenolic and reflow it properly?
> >
> > i guess CEM might be a possible choice
> > every dime is $15K, so this stuff matters
> >
> > we are not going to do a proto, just going right to the run
> > (only kidding!)
> >
> > Dennis Saputelli
> >
> > --
> >

-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to