Tim,

if you use those holes just for the mechanical fixing points, you can create them by 
using Fills in the footprint. If you want to plate them through, there are some PCB 
manufacturers doing it on request. If you want to create them as pads, that is not 
possible. You will have to wait until DXP SE(sixth edition).

Igor

-----Original Message-----
From: Tim Fifield [mailto:[EMAIL PROTECTED]]
Sent: Thursday, 1 August 2002 2:26 AM
To: Protel EDA Form
Subject: [PEDA] rectangle hole?


I'm creating a connector footprint with two rectangle holes or slots for
mechanical stability. How do I create rectangle holes?

Tim Fifield


************************************************************************
* Tracking #: F043784119037E49B6F4845F2C828DF67ED2F5AD
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to