you have more than 16 hole sizes?
can't do with less?
the drill only holds so many bits
Dennis Saputelli
"Robert M. Wolfe" wrote:
>
> To All,
> In my haste to get an answer by covering a few bases
> I posted here. I did find the answer in Knowledge Base
> Item # 1472 there is in fact a limitation in gerber
> drill chart legend, based on what you pick for
> drill representation. I of course always picked symbol
> which was the most limited just my luck. Paste
> boards were either less than 16 or the vendor just
> went with drill data as correct, now I need to check past designs also.
>
> Graphical Symbols 16
> Characters 26
> Size of Hole String 256
>
> Thanks Anyway The design can go out now at least.
> Bob Wolfe
>
> ************************************************************************
> * Tracking #: 60EF39787A3AF34E9485F88A55ADFA8EC8F8758B
> *
> ************************************************************************
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
