So is there nobody who knows how to do this? Tim
-----Original Message----- From: Tim Fifield [mailto:[EMAIL PROTECTED]] Sent: Tuesday, September 10, 2002 11:17 AM To: Protel EDA Form Subject: [PEDA] GND Plane Neck I have 3 GND planes (3 different net names on the sch) I need to neck together on a PCB and cannot figure out how to do it on the schematic and PCB nicely, without errors, and without placing a zero ohm resistor down. Does anybody know how to do this on the schematic and PCB? I seem to recall a thread about a virtual short; is that what I'm looking for? Tim Fifield, CET International Rectifier - Automotive ************************************************************************ * Tracking #: 968D2A22F110544F910DCAC8AE1AB70A02F9C6E4 * ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
