Paul,
        the short circuit design rule does not work, this was established
through a number of users many moons ago.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com
Norsat's Microwave Products Division has now achieved ISO 9001:2000
certification 



> -----Original Message-----
> From: Paul Holland [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, September 11, 2002 5:54 AM
> To: Protel EDA Forum
> Subject: Re: [PEDA] GND Plane Neck
> 
> 
> Hi,
> 
> In the design rules 'Other' section, you can allow short 
> circuits between
> different nets. This should allow you to join the planes 
> together wihtout
> creating errors.
> 
> Hope this helps.
> 
> Paul
> 

************************************************************************
* Tracking #: 51F9C37DDE39EB4F8DC508C203DB99D87A889174
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to