Steve,
        thank you! I had checked every other setting but had figured that
color mode would invoke printer grey scaling and left it set at monochrome.
However, that was it. It prints fine with our color selections and the color
setting.
        I don't understand why it drops out the fill portion because the
outline is the very same color in our schematics.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com
Norsat's Microwave Products Division has now achieved ISO 9001:2000
certification 



> -----Original Message-----
> From: Steve Smith [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, September 19, 2002 10:03 AM
> To: 'Protel EDA Forum'
> Subject: Re: [PEDA] P99SE SP6 SCH print annoyance.
> 
> 
> Check to see that the Color Mode is set to color, not monochrome.
> 
> Steve Smith
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to