Daniel, I am assuming that you are placing the pad in the design, and then made it rectangular and changed its rotation.
Have you tried making the rectangular pad as a component, and then placing it and rotating it, or alternatly, rotating the pad within the component itself. Yet another approach would be placing a "Fill", and then rotating it, either directly in the design, or once again within a component. JaMi Smith ----- Original Message ----- From: "Daniel Webster" <[EMAIL PROTECTED]> To: "'Protel EDA Forum'" <[EMAIL PROTECTED]> Sent: Wednesday, October 16, 2002 10:41 AM Subject: Re: [PEDA] 45 degree pad problem ! > Morning All: > > I have placed some rectangular pads on a 45 degree angle to accomodate a > microstrip design. The problem is that when I generate gerbers, these pads > on an angle have rounded corners. This changes copper layout enough to be a > problem for my RF design. I am wondering if there is a setting in the gerber > generation properties that can be changed to correct this problem. Anyone > have a solution ? > > Thanks, > Daniel Webster > > > > > mailto:[EMAIL PROTECTED] > * > * To leave this list visit: > * http://www.techservinc.com/protelusers/leave.html > * > * Contact the list manager: > * mailto:[EMAIL PROTECTED] > * > * Forum Guidelines Rules: > * http://www.techservinc.com/protelusers/forumrules.html > * > * Browse or Search previous postings: > * http://www.mail-archive.com/proteledaforum@techservinc.com > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
