At 05:09 PM 11/28/2002, Brad Velander wrote:
Here is my issue. Generating Gerbers of a not very complex board (I did this on a much more complex board 2 days ago with no problem), the output Gerber on numerous layers contains inverted circular arcs in numerous locations where polygons should have small inside radius curves. The curve has been reversed. If it was supposed to be 30 degrees of arc, I now have the opposing 330 degrees of the arc.
Software or hardware arcs? (see the gerber settings).
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
