Jami, it was an arc along the edge of a polygon. The problem was with the gerber creation, PCB file was fine, of that arc (actually "those arcs" since there were a number of them) defining the edge of the polygon. It was the gerber that was wrong and generating the opposing portion of the arc which I actually wanted. It was fixed by repairing the DDB, deleting everything within the DDB except for the SCH and PCB files. I had to set-up new cam managers, CFG files, PCB prints, BOMs, etc.. But something in that process fixed it, I am not sure which fixed it because I did everything in one step I was so pissed off.
Sincerely, Brad Velander. Lead PCB Designer Norsat International Inc. Microwave Products Tel (604) 292-9089 (direct line) Fax (604) 292-9010 email: [EMAIL PROTECTED] http://www.norsat.com Check out our fall promotion at www.norsat.com. Limited quantities. Sale ends December 24, 2002. Contact your Account Manager or call 1-800-NII-4LNB or email [EMAIL PROTECTED] > -----Original Message----- > From: JaMi Smith [mailto:[EMAIL PROTECTED]] > Sent: Sunday, December 01, 2002 11:08 AM > To: Protel EDA Forum > Cc: JaMi Smith > Subject: Re: [PEDA] P99SE strikes again on a US vacation long weekend > holiday. > > > Brad, > > First, everything that follows is based on the assumption that you are > talking about a problem with an "Arc", and not in fact a > problem with a > "Polygon", and if that is wrong, then trash everything that follows. > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *