Gisbert, One possibility might be? Protel is not an intelligent enough program to automatically know after synchronization that these traces now in a PCB and attached to pads that now have nets associated with should also be part of that net.
That being said you need go to Design/Netlist Manager and click the Menu button in lower left corner to bring up menu then use "Update Free Primitive From Component Pads" This then makes ALL traces in the whole board that are attached to pads the net associated with that pad. So just be aware when doing this. My feeling is if it was built into the footprint the system should know to make i tpart of the net automatically. Not sure but this may be why your taces do not adhear to rules, I would think if you had online DRC turned on you would also see green for all these tracks vs pads as clear/short errors. Bob Wolfe ----- Original Message ----- From: <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Thursday, December 12, 2002 4:18 AM Subject: [PEDA] Antwort: Rules and PCB library definitions > > Hi, > > I posted the attached message on this forum some days ago, but got no > reponse. Perhaps someone could try to confirm this effect. If it is not a > mistake on my side, it is a very serious bug. I would be grateful if > someone could check if this behaviour also shows under DXP. I just received > my copy of DXP, but have to start the learning curve first, which will take > some time. So I cannot check myself now. > Thank you. > > Mit freundlichem Gru� > Kind regards > > Gisbert Auge > N.A.T. GmbH > www.nateurope.com > > > > > ga@nateurope. > com An: "Protel EDA Forum" <[EMAIL PROTECTED]> > Kopie: > 03.12.2002 Thema: [PEDA] Rules and PCB library definitions > 10:14 > Bitte > antworten an > "Protel EDA > Forum" > > > > > > > > Hello group, > > does anyone know how to overcome the following effect: > > When I define e.g. a BGA component in PCB library editor and include > fanouts and preroutes for the pads, once I have that part placed on the > PCB, the specified rules for clearance, power connection, etc. do not apply > for the preroutes and fanouts, but default to the rules setting for > "board". Is this a bug, and is there some workaround? > > Mit freundlichem Gru� > Kind regards > > Gisbert Auge > N.A.T. GmbH > www.nateurope.com > > > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
