Terry,

DECOMP.EXE is a utiity provided by OrCAD I think. At least in OrCAD SDT 
III times it was so I remember. It is used to transfer OrCAD librarys back 
into an ASCII readable form which then is recognized by Protel.

Regards,
Emanuel

---
MPL AG                                   www.mpl.ch
Emanuel Zimmermann       [EMAIL PROTECTED]
Manager R&D                       Phone: +41 56 483'34'34
Taefernstrasse 20               Fax:      +41 56 493'30'20

CH-5405 Daettwil
---

Terry Creer <[EMAIL PROTECTED]> wrote on 09.07.2003 04:32:00:

> 
> Hi all,
>    Just got a few schematics and a library in Orcad format from the
> Atmel website. The schematics load ok (minus the parts in the .lib 
file),
> but when I try to load the lib file, Protel (99SE) tells me DECOMP.EXE 
must
> be in the path when trying to imort Orcad libraries. Any ideas where I 
can
> aquire this DECOMP.EXE?
> 
> Thanks fellas,
> 
> TC
> 


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to