When I have created a board with blind vias in it, The via pads on inner
layers do not show up when creating a final print out of the board. Is this
a bug? 
The only pad/hole combinations that show up on inner layers are the
'multilayer' pads or vias. But, if I create a via that starts on the top
layer and ends on an inner layer it does not show up on the printout. 


Bill Brooks 
"Politics is more difficult than Physics" - Albert Einstein



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to