most of us turn off component clearance check for a number of good reasons, this among them
Dennis Saputelli Trent Bates wrote: > > I am relatively new to Protel so this is probably an easy question for you > guys. > I am using Protel 99SE > > How do I place parts on top of one another? For example I want to place a > 0805 resistor underneath a Radio module on the same side of the board. > Physically there is space but in the Rules, the Component Distance > Constraint will not let me. I know that "Multilayer Check" will allow me to > place a surface mount part underneath a through hole part if it is on the > other side of the board but I want it on the same side of the board. I know > the answer is obvious but I can't find it. > > Trent Bates -- _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
