"InPolygon" can work, thank you very much.

>On 12:12 AM 26/04/2004, Mr. Zhang Yangtian said:
>>So I add a new clearance rule from "PCB Rules and Constraints Editor" 
>>window via a query "IsPolygon". That is to say that at this time, there 
>>are at least two clearance rules. But the new one does not work! All the 
>>polygon pouring work still follows the first normal clearance setting. So 
>>who can tell me where is wrong. Thank you very much!
>
>DXP/P2004
>
>You need to edit the IsPolygon rule to InPolygon - this is possibly the 
>most commonly asked question and the Rules Wizard gets it wrong (been 
>reported many times).
>
>There is a Protel KB article on this. I found it by searching on the KB 
>page for "polygon clearance":
>http://www.altium.com/protel/kb/kb_item.asp?ID=3678
>
>It has also been addressed many time on the DXP forum.
>
>Ian
>
>
>
>* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
>* To post a message: mailto:[EMAIL PROTECTED]
>*
>* To leave this list visit:
>* http://www.techservinc.com/protelusers/leave.html
>*
>* Contact the list manager:
>* mailto:[EMAIL PROTECTED]
>*
>* Forum Guidelines Rules:
>* http://www.techservinc.com/protelusers/forumrules.html
>*
>* Browse or Search previous postings:
>* http://www.mail-archive.com/[EMAIL PROTECTED]
>* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
>

= = = = = = = = = = = = = = = = = = = =
                        

        致
礼!
 
                                 
        Mr. Zhang Yangtian
[EMAIL PROTECTED]
          2004-04-26

瑕?jg???ザ?⒆??⒒Φ?标?w??姣z?????m??
-y?z烩?(?k⒆ズ谦躇^j鳌?B?Zr?zX?f??ē?h?€vh??j?M?I觑"w?h??'^?薇????
-y?z烩?(?k⒆ズ谦橱璁楂??佶?标+I娅rkz?菏h藏????
&j)Z?b界(?k⒆??⒒Φ?标?w¢

Reply via email to