Dear Sir,

Specify the location on your fabrication drawing and the PC board shop will tape off the unwanted area. Mind you its less expensive just to finish the whole board with the immersion gold.


Thomas Beales

RB Design and Fabrication
621 S. Andreasen Drive, Suite F.
Escondido, CA  92029
Tel : 760-743-7459
Fax: 760-743-1651

Visit us on the web at www.rbdpcb.com


At 09:44 AM 8/27/2004, you wrote:
I've just run across a problem that has never come up before. I need gold
plating on one component in the middle of the top layer- ie not an edge
connector, and don't want the whole board plated in gold. Is there a way to
specify this?


Bob Stephens




Thomas Beales

RB Design and Fabrication
621 S. Andreasen Drive, Suite F.
Escondido, CA  92029
Tel : 760-743-7459
Fax: 760-743-1651

Visit us on the web at www.rbdpcb.com




* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to