I am assuming that you are using DXP (I don't think that you can do this in
99SE)
Go to Design, Rules and highlight Clearance.
The right hand panel will display the rule names and priorities etc.
In the bottom Left hand of the panel there is a button marked Priorities. If
you hit this it will allow you to set the order of precedence.

I hope that this helps.

Ian Capps

----- Original Message ----- 
From: "Cam Andruik" <[EMAIL PROTECTED]>
To: "'Protel EDA Forum'" <[EMAIL PROTECTED]>
Sent: Tuesday, August 31, 2004 9:11 AM
Subject: Re: [PEDA] Net with large clearance and polygon


> How do I do that?
> Cam
>
> -----Original Message-----
> From: Ian Capps [mailto:[EMAIL PROTECTED]
> Sent: August 30, 2004 4:16 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Net with large clearance and polygon
>
>
> You may have to increase the priority of that particular rule.
>
> Ian Capps
> ----- Original Message ----- 
> From: "Cam Andruik" <[EMAIL PROTECTED]>
> To: "'Protel EDA Forum'" <[EMAIL PROTECTED]>
> Sent: Tuesday, August 31, 2004 7:33 AM
> Subject: Re: [PEDA] Net with large clearance and polygon
>
>
> > That's what I have it set for.
> >   A belongs to Net Earth
> >   B belongs to Whole Board
> > Different Nets Only.
> >
> > Cam
> >
> > -----Original Message-----
> > From: Ian Capps [mailto:[EMAIL PROTECTED]
> > Sent: August 26, 2004 5:53 PM
> > To: Protel EDA Forum
> > Subject: Re: [PEDA] Net with large clearance and polygon
> >
> >
> > In Your clearance rule properties try changing your rule attributes to
> > different nets only (99SE).
> >
> > Ian Capps
> > ----- Original Message -----
> > From: "Cam Andruik" <[EMAIL PROTECTED]>
> > To: <[EMAIL PROTECTED]>
> > Sent: Friday, August 27, 2004 6:55 AM
> > Subject: [PEDA] Net with large clearance and polygon
> >
> >
> > > Help please.
> > > I want to set the net EARTH to have a clearance of 97mil.  This is
> > > no
> > > problem, but when I place a EARTH net Polygon Pour it stays away from
> > > everything, including the EARTH Through Hole Pads by 97mils. Cannot
> > > figure out how to edit the rules so the Polygon will stay away from
> > > all nets by 97mils except EARTH net which should default to the rule
> > > for polygon clearance of 12mil. Any suggestions greatly appreciated.
> > >
> >
> >
> >
> >
> >
> >
> >
>
>
>
>
>
>





* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to