On Thu, 11 Jun 2009, fivenote wrote: > Mike, > > To answer your question... > > This started with the stock 2.6.28 kernel from ubuntu without adding > the v4l or standalone pvrusb2 drivers. As soon as I upgraded from > ubuntu 8.10 to 9.04, the problem started. I next compiled and > installed the latest v4l drivers, but got the same results. FWIW, I > never tried the standalone driver, and from your other replies, I > don't think that would have made a difference.
Yes I agree. My suspicion right now is that this has to do with the cx25840 driver which is not part of the pvrusb2 driver (we just use it). > > To clear up my other post about the Hauppage drivers... After seeing > the problem, I downloaded the latest Hauppage Windows drivers (v4.5b > from Jan 2009) and extracted the firmware just to be sure I had the > latest. But this had no effect on the problem. Again, no surprise here. > > I wonder if this is not being reported by others because it's > happening on the analog chip. Maybe most have switched to digital. I > use both analog and digital. I get over-the-air digital in New York > City. In addition, my building provides a basic analog cable package. While the USA is roughly 24 hours away from the switch to digital (right?) there are still a lot cable subscribers on analog and a good chunk of the rest of the world is still on analog (though not NTSC in that case). So I'd have to think that others will have seen this. I definitely didn't see it last time I tested it, which would have been just before the last standalone snapshot release. On the other hand, I could have been an idiot and not noticed it :-) I'm going to look for the problem now however. -Mike -- Mike Isely isely @ isely (dot) net PGP: 03 54 43 4D 75 E5 CC 92 71 16 01 E2 B5 F5 C1 E8 _______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
