Vincent: I'd also like you to do the following:
0. Shut down mythtv backend (if running). 1. Power device off. 2. Wait about 2-3 seconds. 3. Power device on. 4. Wait about 5-7 seconds (to allow the driver to fully initialize so you can get the log messages). 5. Run dmesg, save to a file and send that to me. 6. Stream some video with mplayer, either composite input or an analog RF signal (if you can). 7. While streaming, do "cat /sys/class/pvrusb2/*/debuginfo". Capture output, send to me. 8. Run dmesg again - you'll see a new block reporting "card status". This is an additional effect from cat'ing debuginfo (a log request is generated to all associated drivers). Capture that block to a file and send it to me. That should be enough for me to figure out what state the hardware is getting into, either so I can solve it or at least be able to reproduce the behavior here. -Mike -- Mike Isely isely @ isely (dot) net PGP: 03 54 43 4D 75 E5 CC 92 71 16 01 E2 B5 F5 C1 E8 _______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
