Oh, I ran into that problem too. You might need a newer version or trunk. I'm using AuthKit>=0.4.1dev-r155
I'd have to dig up the emails to remember what the problem was, but it was something to do with that flag only getting applied to either authorize or authenticate, but not both. What version of AuthKit are you using? -r. On Tue, Sep 2, 2008 at 3:26 PM, Mark Mitchell <[EMAIL PROTECTED]> wrote: > > Thanks! > > That makes a lot of sense... I didn't know there was an > authkit.setup.enable flag. I still got an exception though with it > on: > > Exception: Authenticate middleware not present > > Which corresponded to my middleware.py's: > > permission = ValidAuthKitUser() > app = authkit.authorize.middleware(app, permission) > app = authkit.authenticate.middleware(app, app_conf) > > (the last line). > > So I added the following to the shell.ini file you recommended > creating: > > [app:main] > use = config:development.ini > *full_stack = false* > > authkit.setup.enable=false > > By setting the full_stack = false, it didn't even try to run the > authkit setup lines. I think I needed this b/c I have authkit > installed throughout all my application, not just for some > controllers, but requiring every action from every controller to have > a valid logged in user. > > Thanks for getting me on the right track, hope this helps someone, > > -Mark > > On Aug 27, 10:30 am, "Rick Flosi" <[EMAIL PROTECTED]> wrote: > > What I've been doing is using a different config file for running the > paster > > shell. > > > > eg. shell.ini: > > > > [DEFAULT] > > debug = true > > email_to = [EMAIL PROTECTED] > > smtp_server = localhost > > error_email_from = [EMAIL PROTECTED] > > #sqlalchemy.default.echo = True > > > > [server:main] > > use = egg:Paste#http > > host = 0.0.0.0 > > port = 5000 > > > > [app:main] > > use = config:development.ini > > > > *# AuthKit Config > > # disable authkit for paster shell* > > *authkit.setup.enable = false* > > > > "authkit.setup.enable = false" will disable authkit for you. Then run > > `paster shell shell.ini`. > > > > Hope this helps in the short run. > > > > -r. > > > > On Tue, Aug 26, 2008 at 4:35 PM, Mark <[EMAIL PROTECTED]> wrote: > > > > > I installed authkit into my pylons app so it works across all requests > > > of my site. Unfortunately, this makes the paster shell command not > > > work with the following error: > > > > > paste.fixture.AppError: Bad response: 401 Unauthorized (not 200 OK or > > > 3xx redirect for /_test_vars) > > > > > (It's trying to HTTP GET /_test_vars which is protected by authkit on > > > my site). > > > > > Is there a way to pass in authentication details? I've seen previous > > > postings on this before but with no resolution (there was resolution > > > for test fixture support but not for paster shell)... > > > > > Thanks, > > > > > -Mark > > > --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "pylons-discuss" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/pylons-discuss?hl=en -~----------~----~----~----~------~----~------~--~---
