Thanks for all your advice but i finally got it to work. I put the qubide and the goldcard together and got my multimeter. I measured if all the signals from the ql expansion connector where put through the qubide to the gold card. I discovered this way that there was no through connection from the sp0,sp1,sp2,sp3 from the qubide to the gold card. After this i got my ql advanced user guide and saw these where the peripheral select lines so i just soldered 4 wires between the quibide and the gold card to make the connection and viola it worked right away. I am happy everything is working now but the way in which i succeeded is a bit strange i cannot believe it has to be done this way but i made the gamble and it works. Is it normal that the qubide doesn't put these signals through ??
Henk Verbeek. -----Oorspronkelijk bericht----- Van: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]Namens Peter Fox Verzonden: zondag 19 mei 2002 20:04 Aan: [EMAIL PROTECTED] CC: [EMAIL PROTECTED] Onderwerp: RE: [ql-users] gold card and qubide In article <[EMAIL PROTECTED]>, [EMAIL PROTECTED] Sun, 19 May 2002 10:46:43 +0200 (henk verbeek) wrote: > I did this but i still have got the same problem. I also tried another > power > supply but all i get is a blank screen after the first reset. Could it > be > the ql is not getting enough power ? Has anyone got a setup like mine > working ? > > Henk Verbeek. > > -----Oorspronkelijk bericht----- > Van: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]Namens Ron Dunnett > Verzonden: vrijdag 17 mei 2002 20:03 > Aan: [EMAIL PROTECTED] > Onderwerp: Re: [ql-users] gold card and qubide > > > Remove the 68008 it is not needed anymore if you have a Gold or Super > Gold > Card. > > That normally cures the problem you are having. > > Ron > > ----- Original Message ----- > From: "henk verbeek" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Friday, May 17, 2002 1:36 PM > Subject: [ql-users] gold card and qubide > > > > Hello everyone, > > > > I have a standard ql with a qubide and a gold card. If i connect the > > gold > > card or the qubide separatly they work fine but as soon as i put them > > together (quibide first and after this the gold card at the left hand > > slot > > of my classic ql) the ql doesn't boot up anymore. > > I already tried the jumpersettings j3+j4+j5 and j3+j4 only but it > > still > > doesn't work. I know its possible to let them work together but how? > > Does > > anyone have a clue ? or do i have to buy an mplane or something like > > that > ? > > > > Henk Verbeek > > > > > > > > > > > Your problem is not enough power coming out of the standard QL. Behind the microdrives is a voltage regulator with three pins, bent over and attached to a heat sink. This needs a much more powerful regulator which can be got easily in this country. You will need an electronics expert. Hope that this makes sense. Regards, Peter Fox
