I don't think you'll get much benefit from 2 toasters w/out a storage server. I get a headache just thinking about how that would work.
Short of that, I'd be sure to run raid (software raid works well, you don't need a raid card) to protect against disk failure. That's by far the most likely point of failure (other than a power outage). Bogdan Peptine wrote: > Hello, > > I want to have fail over and load balance but i don't to use a storage > server. > If one of the mailservers is going down the ather one to server his job. > I want to use only those two server without any ather storage. > > Thanks > > ----- Original Message ----- From: "Eric Shubert" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Sunday, April 06, 2008 3:28 AM > Subject: Re: [qmailtoaster] qmt replication > > >> Bogdan Peptine wrote: >>> Hello, >>> I have to servers and i want to have QMT replication so both servers to >>> have the same emails allways. >>> I will have both servers to be registered as mx in the dns zone with >>> 10/20 priority. >>> >>> I can do this with QMT? >>> >>> Thanks in advance >>> >> >> This is typically done with a common storage server backend. The >> configuration for such a setup is not trivial. >> >> What are you trying to accomplish? >> >> -- >> -Eric 'shubes' >> -- -Eric 'shubes' --------------------------------------------------------------------- QmailToaster hosted by: VR Hosted <http://www.vr.org> --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
