Could be an air lock somewhere causing localised boiling. Have you tried topping up and leaving overnight then checking the level again?
Matthew -----Original Message----- From: Chris Fairlie <[EMAIL PROTECTED]> Sent: 22 October 2008 17:35 To: [email protected] Subject: [Quantum Owners] Zetec cooling problem I had a problem with my Zetec in the 2+2. It burst a radiator hose and over heated or might have been overeheated and bust a hose. Anyway, I refilled the cooling system and started the car. It ran albeit rough for two minutes and started to spray out of one of the hose connections. I tightened the hose and release the preasure cap. Water came shooting out. I refilled topped up the water and started the engine again. There was a misfire now and after a minute the bottom rad hose blew off. I obviously have excessive preasure in the cooling system and imediatetly thought head gasket gon. I’ve done a compression test and they are between 14 and 150 psi. Seams OK. Any other ideas? Regards Chris Fairlie --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). -~----------~----~----~----~------~----~------~--~---
