Thanks for the advice guys - I've always waited until contact was dry before joining (with evo stick) and never had a problem. I tried it again and kept testing until I thought it was tacky but not wet - joined the 2 together and the roof rectangle is in place- so thanks for the help. I'll finish off the sides tomorrow at leisure, as the fumes nearly overcame me! Jim - did your trimmer use seperate pieces for the A, B, and C pillars or was the roll very wide? The roll I had was not a lot wider than the roof, but ok for length. I anticipated cutting the felt at the screens and 'splaying out' to run down the A and C pillars, but now it's in position I don't think it will mould enough, so I may have to have joins. Regards, Martin --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). -~----------~----~----~----~------~----~------~--~---
