> Constant squeek from cam belt area of engine, despite a number of new > pullies belts etc (The car has been to three garages for this still no > fix)
That might be the auxiliary drive belt that runs round the power steering, water pump and alternator. A little talc puffed on the belt may be all that's needed! ----- Original Message ----- From: "PeteM" <[email protected]> To: "Quantum Owners Group" <[email protected]> Sent: Monday, September 07, 2009 6:50 PM Subject: [Quantum Owners] Re: Refurb my H4 On 7 Sep, 11:11, Stuart Carvell <[email protected]> wrote: > > Other problems > > Slow electic windows especially when they are both used at the same time > (not sure if its normal?) Mine are slow too. I'd put it down to their age (even the youngest donor parts will be nearly 15 years old now) combined with keeping the pressure against the door seals. > Constant squeek from cam belt area of engine, despite a number of new > pullies belts etc (The car has been to three garages for this still no > fix) That might be the auxiliary drive belt that runs round the power steering, water pump and alternator. > Slightly vague steering, suspect universal joint (Problems with gaining a > replacement Ford sourced the replacement for the donor but when it came it > was incorrect. Not sure if the PAS UJ/steering column is different?) Yes it is > Bushes I would like to replace them with Poly but think i personally would > struggle. If it's your daily driver then do you really want the harshness of polybushes? I asked on here a few months ago and based on the advice I'm in the middle of changing the rear axle mounting bushes for a new set of standard Ford bushes. If I'd known how long it would take me to do it then I might have popped it down to the local garage rather than spending hours in B&Q trying to find some tube with an internal diameter of 58mm ..... > Creeking drivers seat Do you have the earlier (seatbelts buckle on a separate stalk) or later (seatbelt buckle attached to the subframe) subframes on the seats? I've got the later ones normally fitted to a mk3.5 (wingback seats) and had a really bad squeak from the drivers seat to the extent that I ended up buying another set of mk3.5 seats for the subframes. I think that the problem is where the seatbelt buckle mounts onto the subframe - if you can tighten the torx bolt up it might help. Pete --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). -~----------~----~----~----~------~----~------~--~---
