Jim Thanks for the offer.
The black electronic module on the side has the following codes on it: 93BB-12B579BA AFH60-02A There are no markings on the alloy casting apart from a manufacture date which has a large 3 in the middle, but nothing round the outside is ledge able. Regards Chris -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jim Hearne Sent: 13 July 2010 21:21 To: [email protected] Subject: Re: [Quantum Owners] Zetec acceleration problem The MAF is the only other part that has to be matched to the ecu. Tell me the part number on yours and i'll look it up on Microcat. Jim On 13/07/2010 20:37, Chris Fairlie wrote: > I've tried 99 Octane fuel, but made no difference. > > Going back to basics can anyone confirm the part numbers to work with a 2.0l > DESK Mondeo ECU on a 2.0l Silver Top Zetec, Fiesta Alloy Inlet manifold and > Brown Injectors. > > MAF > Throttle Body > Throttle Position Sensor > Any other 2.0 Mondeo specific sensors or parts? > > Thanks > > Chris > > -----Original Message----- > From: [email protected] [mailto:[email protected]] > On Behalf Of Matthew Wastell > Sent: 30 June 2010 22:41 > To: [email protected] > Subject: Re: [Quantum Owners] Zetec acceleration problem > > Hi Chris, > > How about filling up with some Tesco 99 octane? This is what I originally > (stupidly) tuned mine to which caused pinking on any other fuel. Might be > worth a go to at least see if it is likely fuel related. I'd say at least to > try a new tank of fuel, I've heard anecdotal of pinking on same octane > different brand fuel. > > I've some octane boost lying about I bought for the Ireland trip as there > was no super available over there, however it didn't seem to help for me. > if you happen to be passing you are welcome to it. Although I doubt it will > prove anything. > > Good luck > > Matthew > > On 30 Jun 2010, at 22:06, "Chris Fairlie"<[email protected]> > wrote: > > >> Thanks for the suggestions. >> >> Definitely sounds like Pinking rather than a knock. >> >> It happened all last week during the Haggis Hunt II with a mixture of >> different brands of petrol (Esso, Jet, BP, Murco etc. ) only one tank of >> Asda fuel. >> >> I checked the plug gaps this evening and they were about 2.5mm. I reduced >> this to the 1.3mm stated in the Haynes manual. Then drove it from cold in >> cooled air. It still pinks. >> >> Any more ideas? >> >> Regards >> >> >> Chris >> >> -----Original Message----- >> From: [email protected] >> > [mailto:[email protected]] > >> On Behalf Of Jim Hearne >> Sent: 28 June 2010 09:12 >> To: [email protected] >> Subject: Re: [Quantum Owners] Zetec acceleration problem >> >> Are you using Tescos petrol ? >> I've noticed my 2.0 Mondeo pinking the last few weeks. >> It's now back to a standard engine spec so shouldn't be due to that. >> >> Jim >> >> >> On 27/06/2010 21:56, Chris Fairlie wrote: >> >>> I have a 2 litre silver top with Ford DESK ecu in a 2+2. >>> >>> It runs well ms of the time, but whenever I try to accelerate hard it >>> >> makes >> >>> a rattling noise like pre ignition. >>> >>> Any ideas what might be causing this? >>> >>> Regards >>> >>> Chris Fairlie >>> >>> -----Original Message----- >>> From: [email protected] >>> >> [mailto:[email protected]] >> >>> On Behalf Of barnacle >>> Sent: 24 June 2010 18:44 >>> To: Quantum Owners Group >>> Subject: [Quantum Owners] Re: Fuel injection question for Jim Hearn >>> >>> Thanks for that Jim. I've ordered the Hadrian injection Mk2 Fiesta >>> tank, which appears to have the outlet in the same place as yours (I >>> assume OEM from the lack of filter?). >>> A filter was definitely on the plan. Should be room for a small one... >>> good tip on the half-inch bend, thanks! >>> >>> So, tank 12mm -> bend 12mm -> filter 12mm -> pump ->8mm -> fuel rail. >>> >>> Ta! >>> >>> On 24 June, 14:15, Jim Hearne<[email protected]> wrote: >>> >>> >>>> The Ford tank has a filter in the tank so you don't need a pre pump one. >>>> A pattern one probably doesn't so one would be a very good idea. >>>> But you need a low pressure filter not a high pressure one. >>>> >>>> Jim >>>> >>>> On 24/06/2010 13:04, barnacle wrote: >>>> >>>> >>>> >>>>> Jim, on this >>>>> >>>>> >>> >> > photohttp://www.quantums.info/pictures/rst_in_2plus2/Fuel%20pump%20in%20fr.. > >>> . >>> >>> >>>>> you show the fuel pump... do you recall the part number, and perhaps >>>>> more critically, the output size of the tank? It *looks* like 8mm, but >>>>> I need to order filter and pump urgently and would hate to then find >>>>> it's 12mm. >>>>> >>>>> >>>> >>>>> I won't be getting the tank till Saturday so I can't measure it! >>>>> >>>>> >>>> >>>>> Thanks, >>>>> >>>>> >>>> >>>>> Neil >>>>> >>>>> >>> >> -- >> You received this message because you are subscribed to the Google Groups >> "Quantum Owners Group" group. >> To post to this group, send email to [email protected] >> To unsubscribe from this group, send email to >> [email protected] >> For more options, visit this group at >> http://groups.google.com/group/quantumowners?hl=en >> >> IMPORTANT NOTE: All information presented herewith is provided on an "As >> > Is" > >> basis, without warranty or the implication thereof. Neither the Quantum >> Owners Club nor the individuals associated with the Quantum Owners Club or >> in the preparation of the above information shall have any liability to >> > any > >> person or entity with respect to liability, loss, or damage caused or >> alleged to be caused directly or indirectly by the instructions contained >> within this or related message(s). >> >> -- >> You received this message because you are subscribed to the Google Groups >> > "Quantum Owners Group" group. > >> To post to this group, send email to [email protected] >> To unsubscribe from this group, send email to >> > [email protected] > >> For more options, visit this group at >> > http://groups.google.com/group/quantumowners?hl=en > >> IMPORTANT NOTE: All information presented herewith is provided on an "As >> > Is" basis, without warranty or the implication thereof. Neither the Quantum > Owners Club nor the individuals associated with the Quantum Owners Club or > in the preparation of the above information shall have any liability to any > person or entity with respect to liability, loss, or damage caused or > alleged to be caused directly or indirectly by the instructions contained > within this or related message(s). > > -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
