yep ive drilled the plate today marking it out on a vernier height gauge, it is spot on accurate offering it up to the bulkhead shows not one hole to line up properly, on the upside the servo brackets mount on the stainless plate a dream and hold the servo correct, so ill use the stainless plate as the datum and correct the 4 bulkhead holes
sigh.... On Feb 6, 7:00 pm, Jim Hearne <[email protected]> wrote: > I don't remember them being not square but i probably did like you and > marked them through from the bulkhead. > > Jim > > On 06/02/2012 16:17, jin wrote: > > > > > ok so all is going well enough but ive come up against another head > > scratcher > > > ive cut out a square stainless plate to mount between the bulkhead and > > servo mounting brackets, (exactly as I have done on the pedal side) I > > used a straight edge across the front of the car using the upper most > > sub frame mounting holes as a datum and held the plate secure while > > scribing through the bulkhead to mark the 4 servo mounting bracket > > holes > > > Once I removed the plate it became clear that something was amiss, the > > holes were out of square with each other in relation to the stainless > > plate which is itself square and was held square to the bulkhead > > > My main question is...... > > > Are the servo brackets to bulkhead holes supposed to be exactly square > > to each other? > > > I thought it best to ask before o go elongating holes > > > my only doubt for this was brought about by realising that the actual > > servo to servo mounting holes appear to be not "square" in relation to > > each other, by which I mean if you line the 2 brackets parallel side > > by side to each other the PCD of the servo to bracket holes would make > > a trapezium shape and not square if that makes sense? > > > Trouble is my bulkhead scribe marks are long gone so I have no > > reference > > > Mine is the type A / low spec setup > > Cheers in advance- Hide quoted text - > > - Show quoted text - -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
