Good idea, just as an extra idea, many years ago i did something similar with sheets of clear printer plastic, print the design on with a coloured printer, make up the design in MS paint (though in sure you have access to something more professional) and stick that over the outside of the graduations between the black housing. then for this situation buy some of that plastic lens repair tape for indicators and put that directly behind each of the white bits on the inside of the housing backed with some aluminum tape to direct the coloured light through the white bits, in fact i like that idea so much im gonna do it straight after I've finished my wheel arch extensions.....
And sorry for rambling all over this thread ;) -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
