Have rebuilt an engine for my zetec xtreme, but cannot get it started. The Omex ECU is not seeing the CPS signal. Have checked all wiring, sensor and signals. Have put an oscilloscope at the ECU end of the wiring and although getting a signal of sorts it is very noisy. I finally decided to check the flywheel holes line up with the sensor hole and it seems there is about 2 or 3mm offset.
Now the question. The new engine is from an automatic. Flywheel etc from my old engine. Can anyone tell me conclusively if the automatic CPS is in a different position to the manual one. A bit if googling indicates it is, so looks like engine out again. Ouch. Nigel -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to quantumowners@googlegroups.com To unsubscribe from this group, send email to quantumowners-unsubscr...@googlegroups.com For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to quantumowners+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.
