Thinking at a tangent..... would it be possible to machine an adaptor that
can be mounted on the outside, yet still achieve the correct position for
the sensor?
Martin
----- Original Message -----
From: "Jim Hearne" <[email protected]>
To: <[email protected]>
Sent: Sunday, July 02, 2017 9:55 AM
Subject: Re: [Quantum Owners] Zetec Crank Position Sensor
Sorry Nigel, the automatic crank sensor mounting is different to the
manual.
The sensor is the same but the aluminium bracket it fits into that then
fits into the hole in block is quite different.
And, of course the bracket is fitted from inside the bellhousing.
http://locostbuilders.co.uk/upload/2tps%20housing.jpg
http://www.kilmartin.it/gallery/picturegallery/crank-trig-hous.jpg
Jim
On 01/07/2017 12:43, Nigel Plant wrote:
Have rebuilt an engine for my zetec xtreme, but cannot get it started. The
Omex ECU is not seeing the CPS signal. Have checked all wiring, sensor and
signals. Have put an oscilloscope at the ECU end of the wiring and
although getting a signal of sorts it is very noisy. I finally decided to
check the flywheel holes line up with the sensor hole and it seems there
is about 2 or 3mm offset.
Now the question. The new engine is from an automatic. Flywheel etc from
my old engine. Can anyone tell me conclusively if the automatic CPS is in
a different position to the manual one. A bit if googling indicates it is,
so looks like engine out again. Ouch.
Nigel
--
--
You received this message because you are subscribed to the Google Groups
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum
Owners Club nor the individuals associated with the Quantum Owners Club or
in the preparation of the above information shall have any liability to any
person or entity with respect to liability, loss, or damage caused or
alleged to be caused directly or indirectly by the instructions contained
within this or related message(s).
---
You received this message because you are subscribed to the Google Groups
"Quantum Owners Group" group.
To unsubscribe from this group and stop receiving emails from it, send an
email to [email protected].
For more options, visit https://groups.google.com/d/optout.
---
This email has been checked for viruses by AVG.
http://www.avg.com
--
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).
---
You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
