On Sat, Jun 03, 2017 at 04:26:56AM -0700, neword via qubes-users wrote: > On Saturday, June 3, 2017 at 9:45:38 AM UTC+1, [email protected] wrote: > > Hi, > > > > I have been frustrated trying to get Qubes fully up and running on the > > Intel NUC7i3BNH. Strangely, I could not get the install working in Legacy > > mode. In EFI mode, the installation went through, but Qubes would not boot > > until I copied the EFI boot files over using the instructions for UEFI > > troubleshooting (under "Boot device not recognised after installing"). > > > > (1) I still get an error on boot that says EFI_MEMMAP is not enabled and an > > error that goes by very quickly that says: > > > > [FAILED] Failed to start Load Kernel Modules > > > > Do I need to worry about this? How can I fix this? > > > > (2) However, the system does indeed boot, and I am prompted to enter my > > LUKS pw and user pw. But, Ethernet is not functioning. I have tried the > > suggestions mentioned already: > > in sys-net, > > (a) linux-firmware-20160609-66.gita44bc811.fc23.noarch is installed. > > (b) lspci shows that Intel I219-V rev 21 is there > > (c) ifconfig does not show ethX in sys-net > > > > I have tried to manually load e1000e / e1000 using modprobe. but no luck. > > > > Any pointers please in how to get networking working? Really frustrated as > > a new Qubes user was really looking forward to this fantastic OS!. > > > > TIA! > > P.S. when I manually load e1000e or e1000 I do not get any errors. It just > shows: > e1000e: Intel Pro/1000 Network Driver - 3.2.6-k > e1000e: Copyright (c) 1999 - 2015 Intel Corporation >
You can just ignore those warnings on boot. On the network issue, I don't think this is really a Qubes problem. It's an issue with the I219 and affects both Fedora and Debian - a quick search confirms this. What's worked for me in the past is using the driver from Intel:the I218-LM has a driver for linux (look on downloadcenter.intel.com), which will give you a v3.3.5.3 e1000e driver - Jessie with kernel 4.4.67-12 has v3.2.6. Download the driver, extract from tar archive, make install. (I should say I haven't done this in a qube, and you'll need the kernel-headers to match your kernel, but it should be straightforward.) On the other hand, trying one of the newer kernels might equally fix it for you. unman -- You received this message because you are subscribed to the Google Groups "qubes-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/qubes-users/20170603222420.GA10976%40thirdeyesecurity.org. For more options, visit https://groups.google.com/d/optout.
