Hi, I have been frustrated trying to get Qubes fully up and running on the Intel NUC7i3BNH. Strangely, I could not get the install working in Legacy mode. In EFI mode, the installation went through, but Qubes would not boot until I copied the EFI boot files over using the instructions for UEFI troubleshooting (under "Boot device not recognised after installing").
(1) I still get an error on boot that says EFI_MEMMAP is not enabled and an error that goes by very quickly that says: [FAILED] Failed to start Load Kernel Modules Do I need to worry about this? How can I fix this? (2) However, the system does indeed boot, and I am prompted to enter my LUKS pw and user pw. But, Ethernet is not functioning. I have tried the suggestions mentioned already: in sys-net, (a) linux-firmware-20160609-66.gita44bc811.fc23.noarch is installed. (b) lspci shows that Intel I219-V rev 21 is there (c) ifconfig does not show ethX in sys-net I have tried to manually load e1000e / e1000 using modprobe. but no luck. Any pointers please in how to get networking working? Really frustrated as a new Qubes user was really looking forward to this fantastic OS!. TIA! -- You received this message because you are subscribed to the Google Groups "qubes-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/qubes-users/ad36bf75-c27c-4873-9289-c53a7855f36c%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
