Hi,
Did you do make install in MD5 installation steps? It is not documented in
README.
However even though you do that (it works fine in Solaris), it gives the
error you have faced in Debian Linux, too. When you do MD5 make install (or
make test, i don't remember well now), it gives two commands: 1 is to remove
old files the 2 is to remove intermediate files. I don't recall which is
which but I ran the first command and it cleans the files.
Then Radiator is happy. :)
Good Luck,
Ferhat
P.S. Solaris installation is just fine for MD5. Linux only problem is I
guess.
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On
> Behalf Of Dialup USA Sales Dept
> Sent: Friday, April 09, 1999 11:50 AM
> To: [EMAIL PROTECTED]
> Subject: (RADIATOR) MD5 Problem
>
>
> When trying to do the "make test" command or "perl
> Makefile.PL" command and
> installing radius im getting the following error message.
>
> Any ideas as to what I need to do to make this work properly.
> I had perl 5
> installed on my FreeBSD system and installed the module 5
> version 1.7 today.
> I got these errors so I upgraded the to the MD 5 version 2.06
> , however I
> am still getting the same errors so now Im thinking it might
> not be the
> modules but instead the perl 5 that im running. Any
> thoughts? Anyone know
> what I should do?
>
> su-2.03# perl Makefile.PL
> Warning: prerequisite MD5 0 not found at (eval 1) line 221.
> Writing Makefile for Radius
> su-2.03#
>
> Then as I do the "make test" I get about 10 of these errors....
>
> Can't load module Digest::MD5, dynamic loading not available
> in this perl.
> (You may need to build a new perl executable which either supports
> dynamic loading or has the Digest::MD5 module statically
> linked into it.)
> at /usr/local/lib/perl5/site_perl/MD5.pm line 8
>
>
> ===
> To unsubscribe, email '[EMAIL PROTECTED]' with
> 'unsubscribe radiator' in the body of the message.
>
===
To unsubscribe, email '[EMAIL PROTECTED]' with
'unsubscribe radiator' in the body of the message.
