The only address you should get from Comcast is for your WAN connection.
You should have a router which will provide NAT (network address
translation) and also allocate your local addresses via DHCP.  It will
also give you a firewall.  I didn't even know that Comcast was even
capable of providing addresses to all devices on your internal network.

Having my own router is the configuration I'm familiar with - perhaps I
came on the broadband wagon late where routers with NAT and DHCP were
common place.

With your own router, you'll have full control.  They aren't hard to
setup anymore.  Connect a lan cable between the cable modem and WAN port
on the router.  Go into the config page for the router and configure the
WAN port as required by comcast.  Then connect everything else into the
LAN port on the router.

Comcast could help you set it up, or you can google tons of info.  Buy a
commonly used router so it's easy to get help.  I recently switched to
comcast from Verizon DSL and needed to find out how to configure my
WRT-54GS running DD-WRT to connect with the cable modem.  I found the
info pretty quickly and it was easy to set up.


------------------------------------------------------------------------
maggior's Profile: http://forums.slimdevices.com/member.php?userid=9080
View this thread: http://forums.slimdevices.com/showthread.php?t=97816

_______________________________________________
Radio mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/radio

Reply via email to