Tom, I had done just that last night. Both regions are set to stretch. The 2nd region wraps to the 2nd column as expected. However the 1st region goes to the end of the first column and does not wrap to the 2nd column.
I tried setting stretch off and expanding the subreport height to the full height in 1st region with the same incorrect results. Maybe Buddy is right that the 1st sub-report will push down into the 2nd sub-report. Time for my thinking cap. Thanks. Bill Eyring -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Tom Frederick Sent: Tuesday, August 11, 2009 9:16 AM To: RBASE-L Mailing List Subject: [RBASE-L] - RE: Sub-Report Question Bill, Can you put a sub inside a region, then place the regions where you want them, and let them stretch? Tom Frederick Elm City Center 1314 W Walnut Jacksonville, IL 62650 O - 217-245-9504 F- 217-245-2350 Email - [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Bill Eyring Sent: Monday, August 10, 2009 6:05 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Sub-Report Question I have a report (3 part check) where I need to put the same sub-report (subReport1 and SubReport2) in the 2nd part of the check and the 3rd part of the check. Each sub-report is set to print 2 columns each 3.88" wide. The purpose is to wrap the remittance advice line items when they reach the bottom of each check part so I get 2 columns of remittance items. I can get the 2nd subreport to wrap but can't get the 1st subreport to wrap, it just pushed the 2nd subreport down further. Any ideas of how I can fix this ? Thanks in advance. Bill Eyring
