Angelo,
I was thinking that Mike Byerly might chime in. I think it is a memory issue with 7.5 that has been fixed by being able to use DLFREE in later versions but I'm not sure. Jan -----Original Message----- From: <[email protected]> To: [email protected] (RBASE-L Mailing List) Date: Wed, 6 Jun 2012 07:27:31 -0700 Subject: [RBASE-L] - Re: Error Messages. Dan Regarding my "RBase" powerpoint, procedure is running on a stand alone pc. Three forms, each for five seconds, approximately 240 revolutions per hour. Right after approximately (three hours) 660 revolutions it locks up. Restart the computer, restart the procedure and again right after approximately (three hours) 660 revolutions it again locks up? ? Thanks for your input, I guess I'll use "real" power point. Angelo From: [email protected] To: [email protected] Subject: [RBASE-L] - Re: Error Messages. Date: Mon, 4 Jun 2012 13:26:21 -0700 <!--{cke_protected}{C}%3C!%2D%2D%0A.ExternalClass%20.ecxhmmessage%20P%0A%7Bpadding%3A0px%3B%7D%0A.ExternalClass%20body.ecxhmmessage%0A%7Bfont-size%3A10pt%3Bfont-family%3ATahoma%3B%7D%0A%0A%2D%2D%3E--> Is it running from the network? If so, it could be connectivity issues. I would check you network card, computer power saving features. Dan From: [email protected] Sent: Monday, June 04, 2012 9:56 AM To: RBASE-L Mailing List Subject: [RBASE-L] - Error Messages. Hello all, I through together a quick three form procedure that just keeps repeating for customer information. My RBase version of powerpoint. After a period time the system locks up with the following two error messages. 1. Access violation at address xxxxxxxx in module RPG75.exe. Write of address xxxxxxxx. 2. Read violation of address xxxxxxxx. Read of address xxxxxxxx. Any suggestions to eliminate these errors. Regards, Angelo
