Marc,
What version and exact build of RBG7 are you using?
01. Check for the correct RBG7.1 installation files, such as:
RBG7.EXE in C:\RBTI\RBG7
RBENGIN1.MSG in C:\Windows or \WinNT
RBENGIN2.MSG in C:\Windows or \WinNT
RBENGIN3.MSG in C:\Windows or \WinNT
RBENGINE.DLL in C:\Windows\System32 or \WinNT\System32
Are there any duplicate files in other directory?
02. What is the date and time on those files?
Hope that helps!
Very Best R:egards,
Razzak.
At 05:26 PM 7/27/2004 -0500, you wrote:
Hi Razzak
I followed the steps and when I tried to open a table this
is the error I got. Also, below is a list of SYS% at the R>
Very Strange.
After I get this error if I disc then con I do not get the error,
but if I quit RBase then con and try to open the table the error
is back.
Even stranger.
What else should I try?
thanks
Marc
---------------------------
Error
---------------------------
SYS_LAYOUTS3 Table Does Not Exist!
---------------------------
OK
---------------------------
Name Columns Rows Comments
SYS_LAYOUTS3 3 3
SYS_MERGE 6 0
SYS_PROCEDURES 10 0
SYS_PROC_COLS 10 0
SYS_PROC_MODS 8 0
SYS_REPORTS 3 0
SYS_REPORTS2 4 121
SYS_REPORTS3 5 121
----- Original Message -----
From: "A. Razzak Memon" <[EMAIL PROTECTED]>
To: "RBG7-L Mailing List" <[EMAIL PROTECTED]>
Sent: Tuesday, July 27, 2004 4:55 PM
Subject: [RBG7-L] - Re: SYS_layout3
>
> Step 02 should read as following:
>
> 02. At the R> Prompt:
> SET MULTI OFF
> CONNECT dbname
> UPGRADE -- that will take care of any missing required table(s).
>
> Razzak.
>
>
> At 04:30 PM 7/27/2004 -0500, Marc Schulter wrote:
>
> >I keep getting an error about can't find sys_layout 3 table.
> >If I do List Sys% I can the table.
> >
> >I remember something about this a few months ago but can't
> >find the post.
>
>
> Marc,
>
> Most likely, you have not followed the instructions to UPGRADE
> your database from 6.x.
>
> So, here's what you have to do:
>
> 01. Start RBG7.1
>
> 02. At the R> Prompt:
> SET MULTI ON
> CONNECT dbname
> UPGRADE -- that will take care of any missing required table(s).
>
> 03. LIST SYS%
>
> The following SYSTEM tables will be added:
> SYS_FORMS3
> SYS_LABELS3
> SYS_LAYOUTS3
> SYS_MERGE
> SYS_REPORTS3
>
> 04. DISCONNECT
>
> 05. SET MULTI ON
>
> 06. CONNECT dbname
>
> Have fun!
>
> Very Best R:egards,
>
> Razzak.
>
>
