Hey Folks: I'm a pretty inexperienced wrench compared to most folks here, so I thought I would float this question to the group. If the solution is a simple one, please take it easy on me!
I bought some new Ultegra bar ends off a list-member several months back with the intention of replacing the older ones I've had on my Sam since '09. I swapped my Albatross setup (and older shifters) over to my wife's Trek 613 a couple of weeks ago, and just this weekend got around to re-assembling my Sam with a new Albastache cockpit. I pulled the Ultegra shifters out of my bin, installed them on the bars, and ran cables. Much to my chagrin, when testing things out, I realized that the left-hand (front) shifter only has enough pull to swap between the granny and middle ring on my Sugino xd2 crankset. It comes to a hard stop and won't pull any more cable. My questions for you are: Is there a version of this shifter that only works for two rings up front? Or did I screw up something on install? Thanks for any help! Bob K. in Baltimore -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To post to this group, send email to rbw-owners-bunch@googlegroups.com. Visit this group at https://groups.google.com/group/rbw-owners-bunch. For more options, visit https://groups.google.com/d/optout.
