The vehicle, T080, weighs 58 lbs.  The motors are 18V drills with 550 size 
motors driven by 18V batteries via Sabertooth 2x25 controller.  I haven't 
checked the gear ratio, but the drill shaft output is reduced a by about 2:1 in 
the chain drive which drives a 4" friction wheel to the tracks.  The system has 
more drag than I'd like, but I can move a track and turn the motors by hand. 
 
 It was a warm day- 80 degrees, and the tank was driven continuously for 28 
minutes or so.  The tank has never been in a battle, but it has a total of 
about 2 hours running time including a battle simulation practice for one hour 
of drive for a while, shoot, scratch your nose, drive some more, etc.  The 
motors were probably driven 50% of the time giving them time to cool off.
 
I should add an outside air fan.  I was just wondering if folks had made mods 
like extra cooling fins on motors other cooling systems.
 
Bill


--- On Mon, 3/26/12, Frank Pittelli <[email protected]> wrote:


From: Frank Pittelli <[email protected]>
Subject: Re: [TANKS] Motor cooling
To: [email protected]
Date: Monday, March 26, 2012, 1:11 AM


Couple questions to help diagnose the problem:

1) How much does your vehicle weigh?

2) What type of motor are you using?  EV Warrior, Scooter, etc.

3) What voltage are you using?

4) What gear ratio are you using between the motors and the drive axle?

    Frank P.

On 3/25/2012 8:10 PM, Bill Byrnes wrote:
> Does anyone ever have problems with motors overheating?

-- You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

Reply via email to