Most drills have a "hi/low" speed/torque setting. If that's the case for the motors you are using, you should ensure that the low-speed/high-torque setting is used all the time. You can't have too much torque when driving tracks, especially friction-drive tracks, and if you have insufficient torque the motors will simply work too hard and overheat. Inexpensive drills use inexpensive motors, which usually provide less power and generate more heat. Stronger motors work more efficiently to move the load, thereby generating less heat.

If you're under-powered (which is the most likely problem given the data you've provided), then one or all of the following remedies could help:

1) Increase the 2:1 drive chain ratio to 3:1
2) Find better motors
3) Remove the heat faster

Back when we used EV Warriors (which also ran very hot) it was not uncommon to see multiple fans and vents moving fresh air over the motors. We also slowed down the vehicle to increase torque. Over time, however, we found motors/gears better suited to the task (scooter motors). Various vehicles are using Dewalt 18V drill motors without overheating issues. Indeed, the motors are warm to the touch after extended use, but not as hot as the EV Warriors used to get.

        Frank P.

On 3/26/2012 5:37 AM, Bill Byrnes wrote:
The vehicle, T080, weighs 58 lbs. The motors are 18V drills with 550
size motors driven by 18V batteries via Sabertooth 2x25 controller. I
haven't checked the gear ratio, but the drill shaft output is reduced a
by about 2:1 in the chain drive which drives a 4" friction wheel to the
tracks.

--
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

Reply via email to