Drills are not from Harbor Freight, but from Northern Tool. Same thing- cheap. There is no inlet for fresh air, but also no outlet for smoke so I can see what color it is. I'm not near the sprockets to count, but I think they are 9 tooth (motor) and 17 tooth. This is "about" 2:1, or (1:2 depending on your perspective). The 9 was the smallest with the correct shaft hole size, and the 17 tooth was the largest that would fit in the hull without cutting the hull. The motors are driven via PWM ESC, not relays (any more). Full speed is a comfortable walk- about 3 mph. The day of the incident, I was driving around at near full speed. I was trying to break the tracks- not the motors. There is always room for improvement. A fanned air hole will be put in, and different motors and gear ratios are possible. Bill
--- On Mon, 3/26/12, [email protected] <[email protected]> wrote: those drills weren't from Harbor Freight, were they? i don't like to by anything powered from them - i tried a dremal (like) tool from them and it melted and dies in about 30 seconds. so your saying there's no inlet for fresh air? but the drill shaft output is reduced a by about 2:1 about 2:1? what sprockets were used? tank wasn't driven that much, nor a heavy tank at that ....... the motor units, are they switch/wired to low or high speed? was your tank racing around? did you have to walk, jog or run after your tank when it was running at full speed? Chris -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat
