Frank, They are made of UHMW plastic. I believe that is the best wearing plastic you can get. I just measured the length I need and counted up the parts available. I need have two lengths, one 73 inches long and one 84 inches long. I need 92 inches, and have enough parts to assemble two 94 inch tracks. Should have my two 92 inch lengths by the end of the day, then it will take a few days to install them. The extra grip, from the rubber pads, may cause the tank to turn hard?? Mark
________________________________ From: Frank Pittelli <[email protected]> To: [email protected] Sent: Friday, November 8, 2013 7:18 AM Subject: Re: [TANKS] Machined Aluminum Track Welcome back. Nice work. Is the drive hub made using Delrin? On 11/6/2013 7:38 PM, Mark_123522 wrote: > I have T074 and have not been active on this site for about 4 years or so, > Check out the all machined track. -- -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat --- You received this message because you are subscribed to the Google Groups "R/C Tank Combat" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out. -- -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat --- You received this message because you are subscribed to the Google Groups "R/C Tank Combat" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
