These cost a little more at $30, but I've found the Wasp's to be rock 
solid.  The weaker predecessor of the Wasp has been spinning the Cromwell 
turret since 05.

http://www.robotpower.com/products/wasp_info.html

ST

On Wednesday, April 22, 2015 at 8:02:15 PM UTC-4, Caleb Smith wrote:
>
> These guys:  
> http://www.hobbyking.com/hobbyking/store/__32025__HobbyKing_X_Car_45A_Brushed_Car_ESC.html
>
> On Wednesday, April 22, 2015 at 8:00:46 PM UTC-4, TyngTech wrote:
>>
>> Which ESC's are you using?
>>
>>
>> On Wednesday, April 22, 2015 at 7:58:15 PM UTC-4, Caleb Smith wrote:
>>
>>> That sounds logical, and I'll look into a receiver battery, but at the 
>>> time I wasn't using the servo, and I burnt two ESC's without even using the 
>>> rotate or elevate.
>>>
>>> On Wednesday, April 22, 2015 at 7:39:23 PM UTC-4, Frank Pittelli wrote:
>>>
>>>> If you were powering the "servo" from the BEC, then the servo could 
>>>> have 
>>>> easily pulled more power than the BEC was capable of providing. 
>>>> Usually, BECs only provide an amp or two and servos can pull more than 
>>>> that when trying to move a heavy load.  Most likely, your elevate servo 
>>>> pulled too much current and blew the BEC circuit in the ESC.  If you 
>>>> power the receiver and servo with a separate battery, all your systems 
>>>> will be happy. 
>>>>
>>>> On 4/22/2015 7:32 PM, Caleb Smith wrote: 
>>>> > I'm just curious if any of you guys (who know a lot more about this 
>>>> sort 
>>>> > of stuff than I do) could give a possible reason to why this is 
>>>> > happening, and what could have caused it? 
>>>>
>>>

-- 
-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

--- 
You received this message because you are subscribed to the Google Groups "R/C 
Tank Combat" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/d/optout.

Reply via email to