The dates of the defective KC-120-1 (and KC-80-1) are from late 1998 to Dec. 
2002. Any modules in the date period will be replaced at no cost by Kyocera. 
Talk about amazing commitment to the customer, these modules only had a 1 year 
defect warranty. 15 years later and they are still replacing them with 
remanufactured units. 

Bill, the typical failure is Voc of about 10 volts. However, the failure can be 
intermittent. For this reason, any modules in the date period should be 
replaced even though they appear to test OK.

Larry Crutcher
Starlight Solar Power Systems


On Jul 2, 2016, at 3:17 PM, Mac Lewis <[email protected]> wrote:

Kyocera had a batch of 120s and 85s that had bad solder connections from a 
certain year. I'm not remembering the year at the moment but we are still 
finding them.

Kyocera has been really amazing about honoring the warranty.


On Jul 2, 2016 2:52 PM, "Jerry Shafer" <[email protected] 
<mailto:[email protected]>> wrote:
Wrenches
Bypass diods fail and may short 
Jerry

On Jul 2, 2016 1:49 PM, "frenergy" <[email protected] 
<mailto:[email protected]>> wrote:
I just came upon a small off-grid system: 12 volt, 4, Kyo 120's (I,mppt= 7.1A; 
Voc = 21.7 or so), Trace C40 with display, etc.   The combiner has fuses for 
each PV/landing.  At noon, output of the array is 10.5 amps.  Clamping the 4 
pvs I get 5.5 amps on 2 PVs and 0.0 on 2 others.  I disconnect leads from 
terminals in PV j-box of the 'dead' PVs and I get Voc=18.5 (pretty hot day) and 
Isc= 6 amps. However when I reconnect these same PVs to the combiner there is 
no change in combined amps.  Fronts and backs of PVs look good, no burns, 
browns, bubbles in backsheet, under the glass looks fine, its all good.  Inside 
the J-boxes look perfect/new.
Ideas?
Thx,
Bill

Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849 <tel:530.284.7849>
CA Lic 874049
www.frenergy.net <http://www.frenergy.net/>        


_______________________________________________
List sponsored by Redwood Alliance

List Address: [email protected]

Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

List-Archive: 
http://www.mail-archive.com/[email protected]/maillist.html

List rules & etiquette:
www.re-wrenches.org/etiquette.htm

Check out or update participant bios:
www.members.re-wrenches.org

Reply via email to